Compatibility - Xerox
Supported Devices
The following Xerox devices are compatible with the most current released version of our Embedded product.
Compatibility Requirements:
Xerox Cost Control Hardware Kit
A Network Accounting or Job Based Accounting (JBA) kit must be installed and activated on each Xerox device by the equipment provider7 inch or larger touch screen
Optional:
Prox Card Reader
If prox cards are used for authentication, an RF IDeas Keyboard Wedge pcProx® RDR-6081AKU reader must be purchased and installed on each Xerox device by the equipment provider
Configuring EIP: https://www.support.xerox.com/en-us/article/en/2121820
Devices Supported | Minimum Firmware |
|---|---|
AltaLink models
VersaLink models
| 121.xxx.xxx.xxxxx or greater is required |
AltaLink models
Xerox models
| Not applicable |
Devices NOT Supported
The following Xerox devices are not compatible or support has been deprecated with the most current released version of our Embedded product.
Devices Not Supported |
|---|
VersaLink models EIP 3.7 Models:
|
All PrimeLink models Models including, but not limited to the following:
|
All WorkCentre models Models including, but not limited to the following:
|
All WorkCentre Pro models Models including, but not limited to the following:
|
All ColorQube models Models including, but not limited to the following:
|
All Phaser models Models including, but not limited to the following:
|
All Versant Digital Press models Models including, but not limited to the following:
|
All Digital Printing Press/Production models Models including, but not limited to the following:
|
All Enterprise Printing System models Models including, but not limited to the following:
|